Difference between revisions of "Presentation/Phase 6"

Latest revision as of 10:12, 28 August 2016

Slide 145 of 176

In Phase 6…
• First on the list is to get a square tote that will be used to enclose the S.H.O. Drive inside.
• Second is to secure plastic spools together and secure them in the center-bottom of the square tote.
• Third is to insert protective edge trim on the handles.
• Fourth is to run an enclosed extended duration test.

Inserting the S.H.O. Drive

(Top)

Square Tote (Phase 6 Parts) • In order to enclose the S.H.O. drive for the following test, I will use a Square Storage Box from The Container Store.  Plastic Spools (Phase 6 Parts) • To better secure the Supreme Stacking Crate from IRIS USA inside the Square Storage Box, I will use the two plastic winding spools (from Phase 3) so I can elevate the crate closer to the lid of the box.  Protective Edge Trim (Parts) • In order to secure the spools together and to center the crate against the indentions on the lid of the box, I will use U Shape Car Door Edge Guard Trim from CarBeyondStore at Amazon.com

Enclosure test

(Top)

Analog Thermometers (Measuring Devices) • To measure the temperature inside and outside the tote during its operation, I purchased a 12-Pack of Sper Scientific 739520 Wall Thermometers from Sper Scientific via Amazon.com  Temperature (Pre-run Testing) • Before I run the device, I will apply some masking tape on each thermometer and write on each the location that each will be placed during the test. • I will then place the thermometers near each other, and away from the windows, for a couple of minutes. Then I will compare their readings.  Temperature (Continuous Testing) • During the continuous testing, I will record their temperature periodically on camera without moving them. • To minimize data noise. I will keep the heater off and the windows and blinds closed. Preferably, clouds would be overcast during this period, or else I could choose to instead conduct the test overnight. • I will put a thermometer wherever window blinds are missing.  Temperature (Post-run Testing) • After the test run, these thermometers will be brought together once again away from the windows to show again for a couple of minutes to see if they give the same reading.

April 2016 Presentation

(Top)

I	Introduction Summary of measuring devices, back up and safety equipment, and camcorder (+accessories)

1	Phase 1 Holes, brass hinges, square nuts

2	Phase 2 Neodymium magnets and bearings

3	Phase 3 Spool, coils, and ceiling hooks

4	Phase 4 No hidden batteries, increase rigidity, hex nuts, terminal rings, toggle switch, fan blades, and extended test run

5	Phase 5 Heavy duty basket, S.H.O. Drive insertion, secure meters, and portable extended test run

6	Phase 6 Square tote, plastic spools, protective edge trim, and enclosed extended test run

7	Phase 7 Prepare elevated test platform, outdoor test setup, camcorder hookup to portable power, and outdoor extended test run

Site map

HQ ● Glossary ● April 2016 Presentation